We have investigated the initial stages of the growth of pentacene thin films on the Au(100) substrate using synchrotron radiation photoelectron spectroscopy (PES), near edge X-ray absorption fine structure (NEXAFS) and scanning tunnelling microscopy (STM). Results indicate a well-ordered structure with the pentacene molecules adopting a predominantly flat orientation with respect to the substrate for coverages of less than three monolayers. NEXAFS and photoemission data indicates the presence of a second molecular orientation for thicker films, with the introduction of a slight tilting away from planar bonding geometry at higher pentacene coverages. STM images of coverages less than three monolayers indicate a well-ordered pentacene structure allowing for the calculation of pentacene unit cell parameters. The pentacene molecular rows adopt a side-by-side bonding arrangement on the surface. For pentacene deposited at room temperature, step edges were observed to act as nucleation centres for film growth. Annealing of the substrate to 373 K was found to remove excess molecules and improve film quality, but did not otherwise change the bonding geometry of the pentacene with respect to the surface. (c) 2006 Elsevier B.V. All rights reserved.